Inflate it, and it's standing
Close one valve, connect the included hand pump and inflate to 4.5 PSI. Five TPU air beams replace rigid poles, so there is nothing to assemble in the dark.
Country













Be sure to select the right options.

Hook the four corners to your 80 cm / 31.5 in cot, connect the pump, and the Neo Nest 80 Air rises on five TPU air beams. No poles to thread, no sections to flex in the dark, and packing down starts by opening a valve.
Inside there is 200 × 80 × 110 cm (78.7 × 31.5 × 43.3 in) of room under a ceiling you can sit up beneath, and the ceiling is mesh: the whole sky, from the cot. When the weather turns, buckle on the included roof cover. It is 3,000 mm silicone-coated nylon over the mesh, with two clear TPU panels so the view stays. For sustained or wind-driven rain, add the Air rainfly (sold separately).
The tent body weighs about 3.3 kg / 7.3 lb, and it pitches on the ground without a cot. Cot, rainfly and door poles are sold separately.
AIR-BEAM COT TENT
Close one valve, connect the included hand pump and inflate to 4.5 PSI. Five TPU air beams replace rigid poles, so there is nothing to assemble in the dark.
Inside is 200 × 80 × 110 cm (78.7 × 31.5 × 43.3 in). The walls flare past vertical, so the room stays wide where your shoulders are.
Mesh runs from the ceiling into both doorways and all four corners: two doors, four corner vents and an open view overhead.
When clouds move in, buckle the included roof cover over the mesh. It is 3,000 mm silicone-coated nylon with two clear TPU panels: light rain stays out, the view stays in.
Two sleeve pockets, two zip pockets and two buckle straps hold the floor to the cot frame. The tent stays put, and nothing hangs over the edges.
The same tent stands on the ground without a cot, staked with the three aluminum pegs in the box. It is built for camps you drive to, not for the trail.
A covered red relief valve opens on its own if pressure climbs above its set level. An extra stroke or a hot afternoon does not stress the beams.
Lantern hook, multi-purpose loop, mesh pocket, roof storage shelf and a cable entry door. Fabric panels zip over the mesh when you want privacy.
Structure
Five TPU air poles of Ø80 mm / 3.1 in run front, rear, left side, center and right side. Two air valves let you close one and inflate through the other, and a covered red pressure-relief valve opens on its own when pressure rises above its set level, venting the excess to protect the beam. The five air-pole zippers are secured with cable ties that protect the inner tubes — leave them in place.
Setup
Set the floor onto the cot, slide the two sleeve pockets and zip the two zip pockets over the corners, then tension the two buckle straps. Close one inlet valve, connect the included hand pump to the other and inflate to 4.5 PSI / 0.31 bar, about 20 strokes. The Air One Pro 22 (sold separately) reaches the same pressure in about 45 seconds. Without a cot, the tent pitches on the ground and takes three aluminum pegs. Then buckle the roof cover on when you want it.
NATURAL OR AIR
The same cot-top footprint and mesh panorama — a different frame, fabric and headroom on each.
Poly-cotton comfort on a classic pole frame
Stands in about 20 pump strokes
Both pitch on an 80 cm / 31.5 in camp cot or freestanding on the ground, and both come with their roof cover. Cot, rainfly and door poles are sold separately.
Set-up size (L × W × H)
220 × 90 × 120 cm
Interior size (L × W × H)
200 × 80 × 110 cm
Packed size (L × W × H)
55 × 25 × 28 cm
Weight (tent body)
approx. 3.3 kg
Specifications
Compatibility
Compatible with the Mount River Wide Cot 80 and cots with the same frame structure and attachment method. Third-party cots may not fit even at identical dimensions. The tent also pitches freestanding on the ground without a cot. Cot, rainfly, door poles and pumps are sold separately.
Ready to order
Mount River
Inflate it over your cot, clip on the roof cover, and camp is set.
SKU: MR-NN80-AIR
Before you order
A one-person air tent sized to a cot
Inside is 200 × 80 × 110 cm (78.7 × 31.5 × 43.3 in): one sleeper, with height to sit up. The tent body is about 3.3 kg / 7.3 lb, and the set with roof cover and hand pump packs to 55 × 25 × 28 cm (21.7 × 9.8 × 11.0 in).
Light rain, yes. A storm, no.
With the included roof cover on, the tent handles showers and light rain. For sustained or wind-driven rain, pitch the Air rainfly (sold separately), and take the tent down when strong wind, heavy rain or snow is forecast. Keep burners, heaters and open flame out of the tent.
Inflate to 4.5 PSI, leave the cable ties alone
Close one of the two inlet valves and pump the other to 4.5 PSI (0.31 bar), about 20 strokes with the included hand pump. The covered red relief valve opens by itself if pressure rises above its set level. The cable ties on the five air-pole zippers protect the inner tubes and must stay on.
Made for an 80 cm cot, or no cot at all
Compatible with the Mount River Wide Cot 80 and cots with the same frame structure and attachment method. Third-party cots may not fit even at identical dimensions. It also pitches on the ground without a cot. Cot, rainfly and door poles are sold separately.
It is built for the Mount River Wide Cot 80 and for cots with the same frame structure and attachment method, at 80 cm / 31.5 in wide. The four corner pockets and two buckle straps depend on how the frame is built, so a third-party cot may not fit even at identical dimensions. If yours is not a match, the tent also pitches on the ground.
Inflate to 4.5 PSI (0.31 bar). The hand pump in the box is enough on its own: close one inlet valve and pump the other for about 20 strokes. The Air One Pro 22 (sold separately) reaches 4.5 PSI in about 45 seconds; the Tornado 25 tops out at 2.5 PSI, so finish with the hand pump if you use it.
For showers and light rain, the roof cover in the box: buckle it over the mesh ceiling, and its 3,000 mm silicone-coated nylon keeps the rain off while the clear TPU panels keep the view. For sustained rain or rain driven by wind, add the Air rainfly (sold separately), which covers the whole tent and adds a vestibule. Take the tent down when strong wind, heavy rain or snow is forecast.
The tent body, the roof cover, a manual air pump, three aluminum pegs with a pouch, two fixing straps and a storage bag. The cot, rainfly, rainfly door poles, sleeping pad and electric pumps are sold separately, so staged photos may show items you need to buy.
Yes. The tent is freestanding and pitches straight on the ground with the three aluminum pegs in the box. It is built for camps you drive to: the tent, cot and pump together are not a backpacking load.
Open both outlet caps and wait about 10 minutes for the beams to empty, then roll from the end opposite the outlets. Packed size is 55 × 25 × 28 cm (21.7 × 9.8 × 11.0 in) in the storage bag, with the roof cover and pump inside. Between trips, store it loosely folded.
What you give up with air beams is a pump; what you get back is a tent that goes from bag to standing in about 20 strokes, on a cot you already sleep on. The roof cover now comes in the box, and that changes how I would use this tent: mesh open for the stars, cover on when the sky closes in, rainfly only when the forecast means it. The 110 cm / 43.3 in interior height is the part people notice, since you sit up in it instead of reversing out of it. Budget for the cot and, for a wet trip, the rainfly.
Kevin G.·Founder · BigTent Outdoors
COMPATIBLE ACCESSORIES
The Air rainfly and door pole set are cut for the Neo Nest 80 Air Cot Tent. The Air One Pro 22 reaches the 4.5 PSI this tent needs; the Tornado 25 tops out at 2.5 PSI, so finish with the included hand pump. All sold separately.
SHIPPING
Three ways to get it.
Express shipping
Air freight + ground
Recommended if you have a specific trip coming up and need it faster. Cost is calculated by package weight.
2-4 weeks
Standard shipping
Ocean freight + ground
Lower cost. Best when you're not in a rush. All duties included, no surprises at delivery.
5-8 weeks
Local shipping
Ground
Ships from our BC warehouse, Canada — already in North America, so there's no overseas leg and no import wait. Orders within North America arrive with no added duties or customs fees. For destinations outside North America, the recipient is responsible for any duties or customs charges on arrival.
3–7 business days